Floor Refinishing in El Macero

El Macero Conditions That Affect Floor Refinishing

El Macero sits at about 36 feet in Yolo County. The regional Sacramento Valley record shows summer air cycling widely within each day rather than staying uniformly dry. In the National Weather Service publication "Climate of Sacramento, California" (revised August 2010), average relative humidity at Sacramento is 78 percent at 4 AM against 30 percent at 4 PM in July, a swing of roughly 48 points inside the same day. Those are Sacramento readings taken about 12 miles from El Macero, not local measurements.

Seasonal Gaps in El Macero Floors, by the Numbers

Seasonal gaps between boards are a common reason people ask about refinishing, and El Macero's measured climate shows how much of that gapping is simply the wood moving with the seasons. Measured at University Airport, Davis, then brought to 70°F, the air averages 37.4% relative humidity over the heating season and 56% over summer, which settles wood at roughly 7.3% and 10.3% moisture content. For a traditional 2¼-inch oak strip floor that is about 0.025 inch of seasonal shrinkage per board (about 1/39 inch); for 5-inch plank, about 0.056 inch. Gaps in that range that open in winter and close by summer should not be filled — filler packed into a winter gap gets crushed out, or pushes the boards toward cupping, once the wood takes its moisture back.

Source: Hourly ASOS dewpoint observations 2015–2025, Iowa Environmental Mesonet (Iowa State University); equilibrium moisture content from USDA Wood Handbook FPL-GTR-190 Eq. 4-5; movement from FPL-GTR-282 Eq. 13-3 and Table 13-5

What's Under the Finish

El Macero is the most uniform ground in this service area by a wide margin. USDA-NRCS SSURGO maps only four soil units inside the CDP boundary, and one of them — Sycamore silt loam, drained — covers 90.1% of it. That unit has a linear extensibility of 2.9%, which places it in the lowest of the four NRCS shrink-swell classes, and no unit anywhere in El Macero exceeds 4.6%. Nothing here is even rated high, let alone very high. Two details are worth carrying into a job. The map units are all mapped on 0 percent slopes and the dominant one carries the "drained" phase, which marks a soil whose natural wetness has been artificially lowered; low-lying basin ground of that kind is flat to begin with but its moisture regime is managed rather than natural, so crawl space and slab moisture readings deserve attention even though the shrink-swell risk is low. The second is the coincidence with the housing data: 86.4% of El Macero's homes were built across three consecutive decades and 90.1% of its ground is a single soil, which makes this one of the few communities where what is found under one floor is a reasonable guide to the next.

A slab affects what can be refinished at all. Wood over concrete is usually engineered or glued-down, and an engineered floor can only be sanded if its wear layer is thick enough to survive it — some can take a full sanding, many can take one light pass, and some cannot be sanded at all. We measure the wear layer before quoting rather than after starting.

Raised floors are where the best refinishing candidates live: solid wood over a crawlspace, often with decades of wear and plenty of thickness left. It is also where cupping comes from. Sanding a cupped floor flat before the crawlspace moisture is fixed produces a floor that goes concave the other way once it dries — so the moisture reading comes first and the sanding comes second.

Source: NAHB analysis of the Census Bureau Survey of Construction, foundation type by region (2024)

El Macero Homes We Work In

ACS 2020-2024 five-year estimates count 360 housing units, 86.4% of which were built between 1960 and 1989 — 31.7% in 1970-1979, 28.6% in 1960-1969, and 26.1% in 1980-1989. The sample records no units built before 1960. This matches the community's origin as a planned golf-course development: the clubhouse, course, and first 175 lots came to market in spring 1961. El Macero's 1960s, 1970s, and 1980s stock is where refinishing pays off most: homes of that period often have original wood under carpet, and when the wear layer is intact, refinishing keeps a floor that cannot be bought new. We check thickness at a vent or a doorway before recommending it.